.png)
.png)
Послать статью по эл. почте 
Открытый доступ
Только для подписчиков
Исследование абразивного износа армированных композитов AA7075/ZrB2
https://doi.org/10.17073/1683-4518-2019-10-38-41
Аннотация
Об авторах
Пардип ШармаИндия
г. Панипат
Нираж Шарма
Индия
г. Харьяна
г. Йоханнесбург, ЮАР
Гурприт Сингх
Индия
г. Нойда
Вишал Дабра
Индия
г. Панипат
Список литературы
1. Mohanty, A. Sustainable bio-composites from renewable resources: opportunities and challenges in the green materials world / A. Mohanty, M. Misra, L. Drzal // J. Polym. Environ. ― 2002. ― № 10. ― Р. 19‒26.
2. Rao, R. Effect of applied pressure on the tribological behaviour of SiC p reinforced AA2024 alloy / R. Rao, S. Das // Tribol. Int. ― 2011. ― Vol. 44. ― P. 454‒462.
3. Rajan, H. M. Effect of TiB 2 content and temperature on sliding wear behavior of AA7075 / TiB 2 in situ aluminum cast composites / H. M. Rajan, S. Ramabalan, I. Dinaharan, S. Vijay // Arch. Civ. Mech. Eng. ― 2014. ― Vol. 14. ― P. 72‒79.
4. Poria, S. Tribological characterization of stir-cast aluminium-TiB 2 / S. Poria, P. Sahoo, G. Sutradhar // Silicon. ― 2016. ― № 8. ― Р. 591‒599.
5. Singh, S. Effect of surface modified silicon carbide particles with Al2 O 3 and nanocrystalline spinel ZnAl2 O4 on mechanical and damping properties of the composite / S. Singh, K. Pal // Mat. Sci. Eng. A-Struct. ― 2015. ― Vol. 644. ― P. 325‒336.
6. Singh, N. Synthesis and tribological investigation of Al‒SiC based nano hybrid composite / N. Singh, I. U. H. Mir, A. Raina [et al.] // Alaxandria Engineering Journal (Article in Press). ― https://doi.org/10.1016/j.aej.2017.05.008.
7. Veeravalli, R. R. Mechanical and tribological properties of AA7075–tic metal matrix composites under heat treated (T 6) and cast conditions / R. R. Veeravalli, R. Nallu, S. M. M. Mohiuddin // J. Mater. Res. Technol. ― 2016. ― № 5. ― P. 377‒383.
8. Kaufman, J. G. Properties of aluminum alloys: tensile, creep, and fatigue data at high and low temperatures / J.G. Kaufman // ASM International. ― 1999.
9. Andreatta, F. Corrosion behaviour of different tempers of AA7075 aluminium alloy / F. Andreatta, H. Terryn, D. J. Wit // Electrochim Acta. ― 2004. ― Vol. 49. ― P. 2851‒2862.
10. Liu, D. Microstructural evolution and tensile mechanical properties of thixoformed high performance aluminium alloys / D. Liu, H. Atkinson, P. Kapranos, W. Jirattiticharoean, H. Jones // Mater. Sci. Eng. A. ― 2003. ― Vol. 361. ― P. 213‒224.
11. Liu, Y. Combined corrosion and wear of aluminium alloy 7075-T6 / Y. Liu, J. Mol, G. Janssen // J. Bio- and Tribo-Corros. ― 2016. ― Vol. 9. ― P. 1‒7.
12. Lakshmipathy, J. Reciprocating wear behaviour of 7075Al/SiC and 6061Al/Al2 O 3 composites: a study of effect of reinforcement, stroke and load / J. Lakshmipathy, B. Kulendran // Tribol. Ind. ― 2014. ― Vol. 36. ― P. 117‒126.
13. Kumar, G. V. Mechanical and dry sliding wear behavior of Al7075 alloy-reinforced with SiC particles / G. V. Kumar, C. Rao, N. Selvaraj // J. Compos. Mater. ― 2012. ― Vol. 46. ― P. 1201‒1209.
14. Baskaran, S. Investigations on dry sliding wear behavior of in situ casted AA7075 – TiC metal matrix composites by using Taguchi technique / S. Baskaran, V. Anandakrishnan, M. Duraiselvam // Mater. Des. ― 2014. ― Vol. 60. ― P. 184‒192.
15. Daoud, A. Effect of Al2 O 3 particles on the microstructure and sliding wear of 7075 Al alloy manufactured by squeeze casting method / A. Daoud, E. M. A. Khair, A. A. Azim // J. Mater. Eng. Perform. ― 2004. ― Vol. 13. ― P. 135‒143.
16. Baradeswaran, A. Influence of B4 C on the tribological and mechanical properties of Al 7075 – B4 C composites / A. Baradeswaran, A. E. Perumal // Compos. Part B. Eng. ― 2013. ― Vol. 54. ― P. 146‒152.
17. Yang, Z. R. Dry sliding wear performance of 7075 Al alloy under different temperatures and load conditions / Z. R. Yang, Y. Sun, X. X. Li [et al.] // Rare Met. ― 2016. ― Vol. 9. ― P. 1‒7.
18. Ruiz, A. M. Wear behavior of aluminum alloys at slow sliding speeds / A. M. Ruiz, A. Conde, D. J. Damborenea, I. Garcia // Tribol. Trans. ― 2015. ― Vol. 58. ― P. 955‒962.
19. Shanmughasundaram, P. Statistical analysis on influence of heat treatment, load and velocity on the dry sliding wear behavior of Aluminium alloy 7075 / P. Shanmughasundaram // Mater. Phys. Mech. ― 2015. ― Vol. 22. ― P. 118‒124.
20. Songli, Z. Microstructures and dry sliding wear properties of in situ (Al3 Zr + ZrB2 )/Al composites / Z. Songli, Z. Yutao, C. Gang, C. Xiaonong // J. Mater. Process. Technol. ― 2007. ― Vol. 184. ― P. 201‒208.
21. Sen, S. Sliding wear behavior of niobium carbide coated AISI 1040 steel / S. Sen, S. Ugur // Wear. ― 2008. ― Vol. 264. ― P. 219‒225.
22. Bing, G. Q. Sliding wear performance of nano-SiO2 / short carbon fiber/epoxy hybrid Composites / G. Q. Bing, R. M. Zhi, J. G. Liang [et al.] // Wear. ― 2009. ― Vol. 266. ― P. 658‒665.
23. Srinivasan, B. P. Sliding wear behavior of salt bath nitrocarburized medium carbon steel / B. P. Srinivasan, C. V. Krishnakumar, N. Krishnaraj // J. Mater. Eng. Perform. ― 2002. ― № 11. ― Р. 509‒515.
24. Mandal, A. Sliding wear behaviour of T6 treated A356‒TiB 2 in-situ composites / A. Mandal, B.S. Murty, M. Chakraborty // Wear. ― 2009. ― Vol. 266. ― P. 865‒872.
25. Sun, H. Q. Sliding wear-induced microstructure evolution of nanocrystalline and coarse-grained AZ91D Mg alloy / H. Q. Sun, Y. N. Shi, M. X. Zhang // Wear. ― 2009. ― Vol. 266. ― P. 666‒670.
26. Deuis, R. L. Dry sliding wear of aluminium composites ; a review / R. L. Deuis, C. Subramanian, J. M. Yellup // Compos. Sci. Technol. ― 1997. ― Vol. 57. ― P. 415‒435.
27. Kumar, S. Tensile and wear behaviour of in situ Al-7Si/ TiB 2 particulate composites / S. Kumar, M. Chakraborty, S. V. Subramanya, B. S. Murty // Wear. ― 2007. ― Vol. 265. ― P. 134‒142.
28. Basavakumar, K. G. Dry sliding wear behaviour of Al‒12Si and Al‒12Si‒3Cu cast alloys / K. G. Basavakumar, P. G. Mukunda, M. Chakraborty // Mater. Des. ― 2009. ― Vol. 30. ― P. 1258‒1267.
29. Zhang, X. Structure and bonding features of ZrB2 (0001) surface / X. Zhang, X. Luo, J. Li [et al.] // Comput. Mater. Sci. ― 2009. ― Vol. 46. ― P. 1‒6.
30. Song, W. Q. The effect of thermal ageing on the abrasive wear behaviour of age-hardening 2014 Al/SiC and 6061 Al/SiC composites / W. Q. Song, P. Krauklis, A. P. Mouritz, S. Bandyopadhyay // Wear. ― 1995. ― Vol. 185, № 1/2. ― Р. 125‒130.
31. Rajesh, S. Solutionizing temperature and abrasive wear behaviour of cast Al‒Si‒Mg alloys / S. Rajesh, D. Anesh, D. K. Dwivedi // Mater. Des. ― 2007. ― Vol. 28. ― P. 1975‒1981.
32. Qi, G. S. Effect of thermal exposure on strength of ZrB 2 -based composites with nano-sized SiC particles / G. S. Qi, Y. J. Ming, T. Hidehiko, K. Yutaka // Compos. Sci. Technol. ― 2008. ― Vol. 68. ― P. 3033‒3040.
33. Zhang, X. Microstructural features and mechanical properties of ZrB 2 ‒SiC‒ZrC composites fabricated by hot pressing and reactive hot pressing / X. Zhang, Q. Qu, J. Han [et al.] // Scripta Mater. ― 2008. ― Vol. 59. ― P. 753‒756.
Дополнительные файлы
Для цитирования: Шарма П., Шарма Н., Сингх Г., Дабра В. Исследование абразивного износа армированных композитов AA7075/ZrB2. Новые огнеупоры. 2019;(10):38-41. https://doi.org/10.17073/1683-4518-2019-10-38-41
For citation: Sharma P., Sharma N., Singh G., Dabra V. Abrasive wear study of AA7075/ZrB2 reinforced composites. NOVYE OGNEUPORY (NEW REFRACTORIES). 2019;(10):38-41. (In Russ.) https://doi.org/10.17073/1683-4518-2019-10-38-41
Обратные ссылки
- Обратные ссылки не определены.