Heat-reflecting ceramic materials based on potassium poly-titanate and silicon oxide.


https://doi.org/10.17073/1683-4518-2018-12-54-57

Full Text:




Abstract

The possibility is studied to obtain the porous ceramic composite with the low heat conductivity and high heatreflecting ability on base of the raw mixture of potassium poly-titanate and different silicon oxide modifications. It was shown that the silicon oxide introduction favors the glass potassium-silicon phase formation which acts as a binding agent and promotes the ceramic composite structure creation, the composite consisting of interwoven high-strength fibrous K2Ti6O13  crystals, bound by means of evenly spread glass phase.


About the Authors

A. V. Gorokhovskii
ФГБОУ ВО «Саратовский государственный технический университет имени Ю. А. Гагарина»
Russian Federation


D. V. Meshcheryakov
ФГБОУ ВО «Саратовский государственный технический университет имени Ю. А. Гагарина»
Russian Federation


I. N. Burmistrov
ФГБОУ ВО «Саратовский государственный технический университет имени Ю. А. Гагарина», г. Саратов; ФГАОУ ВО «Национальный исследовательский технологический университет «МИСиС», Москва
Russian Federation


A. V. Sevryugin
ФГБОУ ВО «Саратовский государственный технический университет имени Ю. А. Гагарина»
Russian Federation


References

1. Gulledge, H. Fibrous potassium titanate ― a new high temperature insulating material / H. Gulledge // Ind. Eng. Chem. ― 1960. ― Vol. 52, № 2. ― P. 117, 118.

2. Gorokhovsky, A. V. Synthesis of potassium polytitanate precursors by treatment of TiO2with molten mixtures of KNO3 and KOH / A. V. Gorokhovsky, J. I. Escalante-Garcia, T. Sanchez-Monjaras [et al.] // J. Eur. Ceram. Soc. ― 2004. ― Vol. 24, № 13. ― P. 3541‒3546.

3. Lee, J. - K. Microstructural evolution of potassium titanate whiskers during the synthesis by the calcination and slow-cooling method / J.-K. Lee, K.-H. Lee, H. Kim // J. Mater. Sci. ― 1996. ― Vol. 31, № 20. ― P. 5493‒5498.

4. Бурмистров, И. Н. Анализ влияния условий получения наноструктурных полититанатов калия на их морфологические характеристики / И. Н. Бурмистров, Д. В. Кузнецов, А. Г. Юдин [и др.] // Новые огнеупоры. ― 2011. ― № 11. ― С. 28‒32. [Burmistrov, I. N. Analysis of the effect of preparation conditions for potassium polytitanates on their morphological properties /I. N. Burmistrov, D. V. Kuznetsov, A. G. Yudin[et al.] // Refractories and Industrial Ceramics. ― 2012. ― Vol. 52, № 6. ― P. 393‒397.]

5. Stanton, M. F. Relation of particle dimension to carcinogenicity in amphybole asbestoses and other fibrous minerals / M. F. Stanton // J. Natl. Cancer Inst. ― 1981. ― Vol. 67, № 5. ― P. 965‒975.

6. Sanchez-Monjaras, T. Molten salt synthesis and characterization of polytitanate ceramic precursors with varied TiO2/K2O molar ratio / T. Sanchez-Monjaras, A. V. Gorokhovsky, J. I. Escalante-Garcia // J. Am. Ceram. Soc. ― 2008. ― Vol. 91, № 9. ― P. 3058‒3065.

7. Gorokhovsky, A. V. Influence of compaction conditions on the structure and mechanical properties of potassium hexat it anat e based ceramics / A. V. Gorokhovsky, T. Sanchez-Monjaras, J. I. Escalante-Garcia [et al.] // Techn. Phys. Lett. ― 2010. ― Vol. 36, № 1. ― P. 37‒39.


Supplementary files

For citation: Gorokhovskii A.V., Meshcheryakov D.V., Burmistrov I.N., Sevryugin A.V. Heat-reflecting ceramic materials based on potassium poly-titanate and silicon oxide.. NOVYE OGNEUPORY (NEW REFRACTORIES). 2018;(12):54-57. https://doi.org/10.17073/1683-4518-2018-12-54-57

Views: 413

Refbacks

  • There are currently no refbacks.


ISSN 1683-4518 (Print)