Microstructure and properties of the mullite‒ZrO2(Y2O3)‒Si3N4-composite ceramics sintered in different ways


https://doi.org/10.17073/1683-4518-2018-7-49-54

Full Text:




Abstract

The research objective was to investigate the packing degree, phase composition, microstructure and some other properties of the mullite‒ZrO2 composite ceramics with the Si3N4 addition sintered in different ways, such as: by the conventional method, by the spark-plasma method, and both in the microwave and solar ovens. The comparative analysis was carried out for the strength properties (these were the ultimate compressing strength and the elasticity modulus) for the ceramic samples which had been sintered by means of the conventional and of the spark-plasma methods. Some reasons for the defect formation in the samples after their sintering in the microwave and solar ovens were mentioned.Ill.8. Ref. 10. Tab. 2.


About the Authors

G. Sedmale
Рижский технический университет, Институт силикатных материалов
Latvia


L. Grasse
Рижский технический университет, Институт силикатных материалов
Latvia


I. Zalite
Рижский технический университет, Институт силикатных материалов
Latvia


N. Zhilinska
Рижский технический университет, Институт силикатных материалов
Latvia


Ya. Rodriges
Platforma Solarde Almeria
Spain


References

1. Malki, M. Electrical conductivity of mullite ceramics / М. Malki, C. M. Hoo, M. L. Mecartery, H. Schneider // J. Am. Ceram. Soc. ― 2014. ― Vol. 97. ― P. 1923‒1930.

2. Rendtorff, N. Mullitezirconia-zirconcomposites: Properties and thermal shock resistance / N. Rendtorff, L. Garrido, E. Aglietti // Ceram. Int. ― 2008. ― Vol. 35, № 2. ― Р. 779‒786. https://doi.org/10.1016/j.ceramint.2008.02.0/.

3. Das, K. Microstructural and mechanical properties of reaction sintered mullite-zirconia composites with magnesia as additive / K. Das, S. K. Das, B. Mukherjеe, G. Barnerjee // Interceram. ― 1998. ― № 5. ― Р. 304‒616.

4. Pereira, D. Sintering of mullite by different methods / D. Pereira, G. R. S. Biasibetti , R. V. Camerini, A. S. Pereira // Materials and Manufacturing Processes. ― 2014. ― Vol. 29, № 4. ― Р. 391‒396. https://doi.org/10.1080/10426914.2013.864400.

5. Hsien-Nan, Kuo. Microstructure and mechanical properties of microwave sintered ZrO2 bioceramics with TiO2 addition / Kuo Hsien-Nan, Chou Jyh-Horng, Liu Tung-Kuan // Applied Bionics and Biomechanics. ― 2016. ― Vol. 2016. ― Article ID 2458685. ― 7 p. http://dx.doi.org/10.1155/2016/2458685.

6. Bodhak, S. Densifcation study and mechanical properties of microwave-sintered mullite and mullite-zirconia composites / S. Bodhak, S. Bose, A. Bandyopadhyay // J. Am. Ceram. Soc. ― 2011. ― Vol. 94, № 1. ― Р. 32‒41. doi: 10.1111/j.1551-2916.2010.04062.x.

7. Souto, P. M. High-temperature diametral compression strength of microwave-sintered mullite / P. M. Souto, M. A. Camerucci, A. G. T. Martinez, R. H. G. A. Kiminami // J. Eur. Ceram. Soc. ― 2011. ― № 31. ― P. 2819‒2826. doi:10.1016/j.jeurceramsoc.2011.07.034.

8. Zhilinska, N. Sintering of nanodisperse powders in a solar furnace / N. Zhilinska, I. Zalite, J. Rodriguez [et al.] // Eur. Powder Met. Conf. 2003 (EuroPM 2003), Valencia, 2003. ― P. 423‒428.

9. Roman, R. Solar sintering of alumina ceramics: microstructural development / R. Roman, I. Canadas, J. Rodriguez [et al.] // Solar Energy. ― 2008. ― Vol. 82. ― P. 893‒902. doi: 10.1016/j.solener.2008.04.002.

10. Седмале, Г. Характеристика муллит‒ZrO2/Y2O3‒SiAlON-керамики в процессе спекания искрового разряда / Г. Седмале, М. Рунданс, И. Шперберга [и др.] // Новые огнеупоры. ― 2016. ― № 3. ― C. 134‒139. [Sedmale, G. Ceramic of the mullite‒ZrO2/Y2O3‒SiAlON system during spark plasma sintering / G. Sedmale, M. Rundans, I. Sperberga [et al.] // Refractories and Industrial Ceramics. ― 2016. ― Vol. 57, № 2. ― Р. 146‒150.]


Supplementary files

For citation: Sedmale G., Grasse L., Zalite I., Zhilinska N., Rodriges Y. Microstructure and properties of the mullite‒ZrO2(Y2O3)‒Si3N4-composite ceramics sintered in different ways. NOVYE OGNEUPORY (NEW REFRACTORIES). 2018;(7):49-54. https://doi.org/10.17073/1683-4518-2018-7-49-54

Views: 380

Refbacks

  • There are currently no refbacks.


ISSN 1683-4518 (Print)