.png)
.png)
Email this article 
Using the spark-plasma technique to produce the mullite-sialon-ZrB2 materials and their properties examination
https://doi.org/10.17073/1683-4518-2018-12-22-30
Abstract
It was shown how the different sialon and ZrB2 ratio in course of the spark-plasma sintering under the pressing load of 75 MPa at 1200‒1600 °C influences the phase composition, the Si3N4 and Al2O3 content in sialon, the microstructure and crystal phases grain size, the density rate and open porosity, the linear shrinkage and physical and mechanical properties, as well as the linear correlation between the elasticity modulus and ultimate compression strength of the mullite‒sialon‒ZrB2 samples.
About the Author
A. V. HmelovLatvia
References
1. Ghahremani, D. Densification, microstructure and mechanical properties of mullite‒TiC composites prepared by spark plasma sintering / D. Ghahremani, T. E. Ebadzadeh // Ceram. Inter. ― 2015. ― Vol. 41, № 2. ― P. 1957‒1962.
2. Chuan, S. Effect of alumina addition on the densification of boron carbide ceramics prepared by spark plasma sintering technique / S. Chuan, L. Yunkai, W. Yunfei, Z. Lingbo // Ceram. Inter. ― 2014. ― Vol. 40, № 8. ― P. 12723‒12728.
3. Hotta, M. Densification and microstructure of Al2O3‒cBN composites prepared by spark plasma sintering / M. Hotta, T. Goto // J. Ceram. Soc. Jap. ― 2008. ― Vol. 116, № 6. ― P. 744‒748.
4. Hotta, M. Densification, phase transformation and hardness of mullite‒cubic BN composites prepared by spark plasma sintering / M. Hotta, T. Goto // J. Ceram. Soc. Jap. ― 2010. ― Vol. 118, № 2. ― P. 157‒160.
5. Хмелёв, А. В. Получение муллито-циркониевой керамики плазменно-искровым способом / А. В. Хмелёв // Новые огнеупоры. ― 2014. ― № 4. ― С. 33‒38. [Hmelov A. V. Production of a mullite‒zirconia ceramic by the plasma-spark method / A. V. Hmelov // Refractories and Industrial Ceramics. ― 2014. ― Vol. 55, № 2. ― P. 137‒142.]
6. Хмелёв, А. В. Получение муллит‒TiC‒ZrC-керамических материалов плазменно-искровым способом и их свойства / А. В. Хмелёв // Новые огнеупоры. ― 2016. ― № 12. ― С. 36‒41. [Hmelov A. V. Preparation of mullite‒TiC‒ZrC ceramic materials by a plasma-ARC method and their properties / A. V. Hmelov// Refractories and Industrial Ceramics. ― 2017. ― Vol. 57, № 6. ― P. 645‒650.]
7. Kelvin, Y. X.Effect of alumina on the structure and mechanical properties of spark plasma sintered boron carbide / Y. X. Kelvin, F. T. Muhammet, K. Kanak, Z. Binwei // J. Am. Ceram. Soc. ― 2014. ― Vol. 97, № 11. ― P. 3710‒3718.
8. Klimczyk, P. Al2O3‒cBN composites sintered by SPS and HPHT methods / P. Klimczyk, M. E. Cura, A. M. Vlaicu // J. Eur. Ceram. Soc. ― 2016. ― Vol. 36, № 7. ― P. 1783‒1789.
9. Zhang, X. Effect of Y2O3 on microstructure and mechanical properties of ZrB2‒SiC / X. Zhang, X. Li, J. Han, W. Han // J. All. Comp. ― 2008. ― Vol. 465, № 1/2. ― P. 506‒511.
10. Guo, S. High-strength zirconium diboride-based ceramic composites consolidated by low temperature hot pressing / S. Guo, Y. Kagawa // Sci. Techn. Adv. Mat. ― 2012. ― Vol. 13, № 4. ― P. 1‒6.
11. Calloch, P. New reaction paths for advanced SiAlON / TiN composites / P. Calloch // A thesis submitted to Victoria University of Wellington. ― 2015. ― P. 8‒12.
12. Хмелёв, А. В. Получение муллит‒TiC‒TiN-материалов плазменно-искровым способом и их свойства / А. В. Хмелёв // Новые огнеупоры. ― 2017. ― № 8. ― С. 22‒30. [Hmelov, A. V. Preparation of mullite–TiC–TiN materials by a plasma spark method and their properties / A. V. Hmelov // Refractories and Industrial Ceramics. ― 2017. ― Vol. 58, № 4. ― Р. 418‒425.]
Supplementary files
For citation: Hmelov A.V. Using the spark-plasma technique to produce the mullite-sialon-ZrB2 materials and their properties examination. NOVYE OGNEUPORY (NEW REFRACTORIES). 2018;(12):22-30. https://doi.org/10.17073/1683-4518-2018-12-22-30
Refbacks
- There are currently no refbacks.